MAD ADDER

Mustang GT Drag Car 

1986 Mustang GT  DSS 306 Procharger 422rwhp

1989 Bronco          CCM 302 Vortech 349 rwhp

HOMESVO MustangMustang GTPowder CoatingMad Adder, LLC
   Here are some pictures of my 1986 Mustang GT drag car and a few of my 1989 Bronco. The Bronco is sold and will soon be shipped...to CALIFORNIA !! The GT spends its time on the trailer waiting to be raced again.
   The Mustang has stock hatch and doors, other than that everthing else has been replaced for the Go-Fast mission. The short list....DSS 306, Procharger P600B (one of the first kits when they came out and still going strong!!!) w/ 3-core intercooler, Edelbrock heads and RPM intake, Mac long tubes and custom exhaust, full race fuel system, Cobra computer and Pro-M Bullit meter, Performance Automatic C-4, ...and the list keeps going. On the dyno, at Second Street Speed, it put 422 hp to the rear wheels. Best time with a Z-spec  T-5 was 10.77 @ 127 mph in the quarter mile. After switching to the C-4 it dropped to 10.33 @ 129 mph. Drag car is FOR SALE !!  $15,000 firm
  

   Here are a few shots of the Bronco.  It started off with just a 5-lb Vortech kit and then parts that came off the Mustang found a new home on the Bronco. When a new engine was needed a CCM GT40P long block with an E303 was ordered. Hedmann long tubes and 3" pipe make up the exhaust. A FMS mass air conversion and Pro-M air meter were added along with 36-lb injectors, Bosch pump, and 1/2" feed lines. An Edelbrock intake and 65mm tb came from the Mustang. LEVEL10 in New Jersey rebuilt the AOD to Stage 3 specs. Fully loaded with car in tow it would accelerate up steep hills !!! On the dyno it put 349 hp to the rear wheels with a conservative tune. Not sure where the engine/trans are going next......
Copyright 2005 Anthony Tinklepaugh. All rights reserved.